Skip to content
Fleetee logoFleetee logo

Connect data has stopped coming in: what should I do?

  • Connect v3
  • Administrator
  • Agency manager

In short. First look at the “Last synchronisation” date in the vehicle’s Digital key panel. Nothing is read again when you open it: click “Synchronise”. A tracker with no GPS signal keeps its previous position. If the tracker is no longer found, check the registration number at Fleeti.

An equipped vehicle’s data (mileage, fuel, position) is read in Manager, on the vehicle page, Digital key panel. Here are the causes, one by one.

Cause 1: the data hasn’t been read again

Opening the panel doesn’t contact the tracker: you see the last stored reading, with its date (“Last synchronisation of the tracker: …”). Click Synchronise to read the tracker again.

Cause 2: the tracker has no signal

A tracker with no signal, in an underground car park for example, sends no new position: the map shows the previous one. The date shown is that of the synchronisation, not necessarily that of the position. Wait until the vehicle is in the open, then synchronise again. With no position at all: “No known position: the tracker has not sent one yet.”

Cause 3: the reading failed

  • “The digital key could not be read again: what is shown may be out of date”: click Try again.
  • “The digital key service cannot be reached. Nothing was changed”: try again in a few moments.

Cause 4: the tracker is no longer found

“No tracker found for the registration number …”: the vehicle’s registration number in Fleetee no longer matches the tracker’s at Fleeti. Check it with the provider (Open the provider’s site), then try again.

Cause 5: fuel no longer shows

The Read the fuel from the tracker switch may be off: the level is then entered by hand in inspections. Switched back on, it returns at the next synchronisation.

For the panel in detail, see How do I follow a vehicle’s digital key?.

Was this article helpful?

Write to support

Ask the assistant: “…”coming soon